Broseley eVolution 7 Insert Instructions d'exploitation télécharger pdf (Page 13)

Assembly

The images below detail the sequence for installing the internal firebricks in the eVolution 4

1. Ensure there is no ash are debris to prevent the

firebricks installation.

2. Start by installing the left side firebrick as shown.

3. Insert the right side firebrick but this time lean it towards

the left brick as shown.

4. Insert the baffle, lift the baffle upwards towards the roof

with one hand and with your other hand stand the right

firebrick upright as shown. You can now lower the baffle

so that it rests on each of the side firebricks as shown.

5. Insert the rear firebrick, use one hand to lift the baffle up

slightly then position the rear firebrick and lower the

baffle onto it as shown.

6. Finally install the log retainer one side at a time.

To remove the firebricks simply reverse this sequence.

MS11-11 Issue 3 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Pas de commentaire

Broseley eVolution 7 Insert Instructions d'exploitation Page 13